Revision log, 7 revision log – Detcon DM-100 User Manual
Page 44
Model DM-100
DM-100 Instruction Manual
Rev. 3.3
Page 40 of 40
8.7 Revision Log
Revision
Date
Changes made
Approval
0.0
09/01/2010
Initial Release
LU
0.1
11/08/2010
Update to Cross Interference table to correct wrong value for
C2H3CL against CO. Previous value was 1250=100, corrected
value is 200=100
LU
0.2
11/17/2010
Added updated table for Jumper descriptions and Jumper
settings on DM-100 Terminal Board
LU
0.3
11/30/2010
Corrections to Cross Interference Table, and some spelling
LU
1.0
02/02/2011
Revised ATEX operational guidelines. Updated manual to
reflect most current template. Made significant changes due to
creation of Wireless DM-100 manual so manuals can
complement each other. This includes removing duplicate
tables and figures, adding/modifying tables and figures,
updating drawings, adding/modifying sections, etc.
BM
1.1
02/15/2011
Added additional notes required by approval agencies.
LU
1.2
04/06/2011
Added references to 100 Series Bottom Housing Assembly with
integral filter. Added 100 Series Bottom Housing Assembly
with integral filter to spare parts. Modified troubleshooting
section to reference use of 100 Series Bottom Housing
Assembly with integral filter
BM
1.3
04/13/2011
Add additional guidelines in 2.1 per ATEX requirements.
VR
1.4
06/02/2011
Added “DM-200L Toxic Gas Sensors” on Cover Sheet
LU
1.5
08/01/2011
Added DM-100 intrinsically safe installation notes drawing to
back of manual.
LU
2.0
08/17/2011
Updated Terminal Boards, new display
LU
3.0
10/5/2012
Added AutoZero and AutoSpan
LU
3.1
11/22/13
Corrected instructions for performing span with no display
LU
3.2
12/26/13
Added Wind Guard to Calibration Procedure
BM
3.3
01/30/14
Stress and highlight parts of span calibration for O2 sensors
BM
Shipping Address: 4055 Technology Forest Blvd, The Woodlands, Texas 77381
Mailing Address: P.O. Box 8067, The Woodlands Texas 77387-8067
Phone: 888.367.4286, 281.367.4100 • Fax: 281.292.2860 •
•