Detcon DM-200 - Manual (Page 23)

Model DM-200
DM-200 Instruction Manual Rev. 2.0 Page 19 of 40
3.6.1 View Program Status
The following procedure is used to view the programming status of the sensor:
b)
Enter the programming menu by holding the programming magnet stationary over “PGM 2” for 15
seconds until the display reads “VIEW PROG STATUS”, and then withdraw the magnet. At this
point you can scroll through the programming menu by momentarily waving the programming magnet
over “PGM 1” or “PGM 2”. The menu options are: View Program Status, Set Span Level, and Set
Date.
c)
Scroll to the “VIEW PROG STATUS” listing and then hold the programming magnet over “PGM 1”
for 3 seconds. The menu will then automatically scroll, at 3 second intervals, through the following
information before returning back to the “VIEW PROG STATUS” listing.
1. The sensor type. The menu item appears as: “Sensor Type / CO”
2. The sensor range of detection. The menu item appears as: “Sensor Range / 0-100 PPM”
3. The ISM software version number. The menu item appears as: “ISM Code Ver. / 1.10 Apr
2001”
4. The UTM software version number. The menu item appears as: “UTM Code Ver. / 1.10 Apr
2001”
5. The time weighted average and peak. The menu item appears as: “TWA: xx PPM / PK: xx
PPM@ –xx Min”
6. The estimated remaining sensor life. The menu item appears as: “Sensor Life / 100%”
7. The calibration span gas level setting. The menu item appears as: “Auto Span Level / 50 PPM”
8. The date. The menu item appears as: “Present Date/ 5/1/01”
9. The last successful span date. The menu item appears as: “Last Span Date / 5/1/01”
10. The temperature. The menu item appears as: “Present Temp / 23°C”
d)
Exit back to normal operations by holding the programming magnet over “PGM 2” for 3 seconds, or
automatically return to normal operation in 30 seconds.
3.6.2 Set Date
The following procedure is used to set the present calendar date:
a)
Enter the programming menu by holding the programming magnet stationary over “PGM 2” for 15
seconds until the display reads “View Program Status”, and then withdraw the magnet. At this point
you can scroll through the programming menu by momentarily waving the programming magnet over
“PGM 1” or “PGM 2”. The menu options are: View Program Status, Set Span Level, and Set Date.
b)
From the programming menu scroll to the “Set Date” listing. Enter the menu by holding the
programming magnet stationary over “PGM 1” for 3 seconds until the display reads “Set Date /
xx/xx/xx”, and then withdraw the magnet. The first set of numbers (month) will flash on and off
indicating they are ready for adjustment. Use the programming magnet to make an adjustment to
“PGM 1” to increase or “PGM 2” to decrease the display reading until the reading is equal to the
desired month.
c)
Next, advance to the second set of numbers (the day) by holding the programming magnet stationary
over “PGM 1” for 3 seconds until the month set flashes on and off indicating they are ready for
adjustment. Use the programming magnet to make an adjustment to “PGM 1” to increase or “PGM 2”
to decrease the display reading until the reading is equal to the desired day.
d)
Next, advance to the third set of numbers (the year) by holding the programming magnet stationary
over “PGM 1” for 3 seconds until the year set flashes on and off indicating they are ready for