DeFelsko PosiTector PC v.2.0 - Manual (Page 6)

5
The PosiTector body accepts a number of probe types including
magnetic, eddy current and ultrasonic coating thickness, surface
profile, environmental and ultrasonic wall thickness probes.
For the latest information on probe interchangeability,
see www.defelsko.com/probes
Probes Probes
Maintenance
The screen at the measuring end of the PC probe can be
unscrewed for cleaning. Accumulated powder should be carefully
removed from the screen by no more than 0.2 MPa (20 - 30 psi)
of compressed air. Do not blow air directly into the probe.
Replacement screens are available.
Wireless Powder Checker probes:
The PosiTector PC wireless probe connects to all Advanced
PosiTector bodies. See Powder Probes (pg 13) for connection
details.
Physically connected PosiTector probes:
To disconnect a probe from a PosiTector body, slide the
plastic probe connector horizontally (in the direction of
the
arrow) away from the PosiTector body.
Reverse these steps to attach a new probe.
The PosiTector automatically determines what type of
probe is attached and does a self-check.
During power-up a physically connected probe is
recognized when a PC probe is not available (powered-off).
To reconnect to a PC wireless probe (after power-up), select
Connect, within the Connect > Powder Probes menu. (pg 13)
The PosiTector body will automatically connect to an active
wireless PC probe during power-up. PC probe must be turned on.
NOTE: