DeFelsko PosiTector 200 v.3.0 Quick Guide - Manual (Page 2)

1
Introduction Introduction
The PosiTector 200 is a hand-held Coating Thickness Gage that
uses a non-destructive ultrasonic principle to measure coating
thickness on a wide variety of substrates. It consists of a body
(Standard or Advanced) and a probe (see Probes pg. 2).
This Quick Guide summarizes the basic functions of the Gage.
Download the full instruction manual at:
www.defelsko.com/manuals
Quick Start Quick Start
The PosiTector 200 powers-up when the center navigation button
is pressed. To preserve battery life, the instrument powers
down after approximately 5 minutes of no activity. All settings are
retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation button.
3. Zero the probe. (see pg. 5)
4. Adjust to a known thickness, if necessary. (see pg. 6)
5. Measure the part. (see pg. 3)
Up
Down
Center
To navigate, use the Up and Down buttons to
scroll and to SELECT.
Select Exit to exit from any menu.
Navigation Button
The center button is purposely recessed to help
eliminate unintentional powering-up of the gage.
Menu Operation Menu Operation
Gage functions are menu controlled. To access the Menu, power-
up the gage, then press the center navigation button.
NOTE: