Limited warranty, sole remedy, Returning for service – DeFelsko PosiTector 200 v.3.0 Quick Guide User Manual

Page 13

www.defelsko.com

or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other

countries. Other brand or product names are trademarks or registered trademarks of their respective

holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not

responsible for printing or clerical errors.

Limited Warranty, Sole Remedy

and Limited Liability

DeFelsko's sole warranty, remedy, and liability are the express

limited warranty, remedy, and limited liability that are set forth on

its website: www.defelsko.com/terms

Returning for Service

Before returning the Gage for service…
1.Install new or newly recharged batteries in the proper alignment

as shown within battery compartment.

2.Examine the probe tip for dirt or damage.
3.Perform a Hard Reset (pg. 7) and a Zero (pg. 5).
4.Place a plastic shim onto a hard surface (i.e. glass) and attempt

a measurement. (pg. 3)

If you must return the Gage for service, describe the problem fully

and include measurement results, if any. Be sure to also include

the probe, your company name, company contact, telephone

number and fax number or email address.
Website: www.defelsko.com/support