DeFelsko PosiTector 6000 v.7.3 Quick Guide - Manual (Page 2)

Introduction Introduction
The PosiTector 6000 hand-held, electronic Gage non-
destructively measures the thickness of coatings on metals,
quickly and accurately. It consists of a body (Standard or
Advanced) and probe (Built-In or Separate).
This Quick Guide summarizes the basic functions of the instru-
ment. Download the full instruction manual at:
www.defelsko.com/manuals
The PosiTector 6000 powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity. All
settings are retained.
1
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation button.
3. Place the probe FLAT on the surface to be measured. HOLD
STEADY. When a valid measurement is calculated, the Gage
BEEPS twice and the measurement is displayed.
4. Lift probe AT LEAST 2 INCHES (5cm) from the surface between
measurements - OR - leave probe on the surface in the same
location for continuous measurements.
Quick Start Quick Start
Up
Down
Center
To navigate, use the Up and Down buttons to
scroll and to SELECT.
Select Exit to exit from any menu.
Navigation Button
The center button is purposely recessed to help
eliminate unintentional powering-up of the gage.
Menu Operation Menu Operation
Gage functions are menu controlled. To access the Menu, power-
up the gage, then press the center navigation button.
NOTE: