COSA Xentaur COSA 9610 - Manual (Page 21)

INSTALLATION, OPERATION AND MAINTENANCE MANUAL – COSA 9610™
Page 21 of 44
3.2. S
TART
-U
P OF THE
C
ONTROL
U
NIT
This chapter describes the procedure to start up the control unit. When a machine is
being started up for the first time a gas calibration has to be done first.
3.2.1. Description
3.2.2. Programming the measurement parameters
Programming the COSA 9610™ is easy with the menu-controlled software. Menu can be
navigated using the cursor keys. The key operations are:
Key Menu navigation Change setting value
" or Enter Select menu item Accept value change
# or Esc Go back to previous menu Undo value change
$ Go up one menu item Go to previous item value
% Go down one menu item Go to next item value
To enter the main menu screen, press " or the Esc. The screen now presents some
functions that can be selected by the cursor keys or by typing the number associated to
the menu item. To resume normal operation, press # or Esc until the main screen to
appear. To change a setting value on menu, select the item and enter the new value.
For setting item with selection (e.g. On/Off), select the desired value using $ and %
keys.
3.2.3. Main screen
The main screen is divided into section, each representing data, status or charts as see in
the figure below. Graphical chart trend data can be changed to any of the calorific,
density or other values shown on the main screen.