Catskill Craftsmen 1480DOR - Manual (Page 13)

1 3/4 machine
screws from back side
Hex Nut
Drawer Glide Supports
Illustration 9D
Illustration 9E
TIP: Place a towel or tablecloth
(movable) on the table, that will
allow you to rotate the Back
Assembly without scratching the
tabletop.
Illustration 9F
C. Insert the Side Panels
into the slots of the Bottom/
Middle Side Braces. Best
side out! (Illustration 9F)
E. Attach the Drawer Glide
Supports. Start by aligning
the 2 Pins in each end of the
Sticks into the pin holes in
the leg. Make sure Glide is
positioned as illustrated in
9E and 9F.