WEN 70712 12 Sliding Compound Miter Saw - Manual (Page 25)

ITEM 70712 OPERATOR’S MANUAL 25
TROUBLESHOOTING
Problem Possible Causes Likely Solutions
Miter Saw will not start. No power at outlet. Check power at outlet.
Cord not connected. Check that cord is plugged
into outlet.
Miter Saw operates
sporadically or at low power. Low power supply or
improper extension cords. Check power supply and
power cords.
Worn or cracked carbon
brushes. Check Carbon Brushes.
Replace if damaged or worn.
Wood burns at ends when cut. Dirty blade. Clean blade using blade
cleaner or mineral spirits.
Material is binding. Check position of work piece
on Table.
Material frays or chips out. Finished side is down. Always have finished side of
material up or facing you.
Blade is chopped or dull. Bottom and back side are
prone to chip out.
Blade is inappropriate for
material. Check for damaged teeth.
Sharpen or replace blade.
Material is unsupported. Check blade manufacturer's
recommendations for material
being cut. For cross cutting
hard wood and for precision
cuts use a thin Kerf blade with
60 or more teeth.
Blade binds, slowing or
stopping saw. Material is misaligned on the
saw or ends are not supported. Material must be flat on table,
flush against the Guide Fence
and support on both ends.
Material is wet, contaminated
or inappropriate blade is being
used. Check condition of material
and check compatibility of
blade to material.
Follow all safety precautions whenever diagnosing or servicing your Miter Saw. Disconnect
power supply before service.