WEN 70712 12 Sliding Compound Miter Saw - Manual (Page 21)

ITEM 70712 OPERATOR’S MANUAL 21
18. Test the operation of your saw prior to cutting a work piece. If you feel excessive vibration or
hear an unusual noise, immediately stop operating the saw. Correct the problem before
continued use.
19. Allow movement of the waste portion of the work piece. Do not hold it, clamp it, touch it or
use a length stop against it. The cut-off waste portion must be free to move. It could become
wedged against the blade causing a hazard.
20. Avoid awkward hand positions. It is important to position your hand no closer than four (4)
inches from the blade.
21. Do not cross your arms in front of the blade while operating the saw.
22. Do not force the blade through the work piece. Lower the blade through the work piece fast
enough to allow the blade to cut without binding or bogging down.
23. Before removing obstructed material, release the trigger switch/start button, wait for the
blade to stop moving and unplug the power cord from the electrical outlet.
24. After completing a cut, keep the Handle in the down position. Release the trigger switch/start
button and wait for the blade to stop moving.
MAINTENANCE AND SERVICE
Cleaning, Maintenance and Lubrication
1. Before each use inspect the general condition of the tool. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring,
and any other condition that may affect its safe operation.
2. After use clean external surfaces of the tool with clean, moist cloth. To prevent accidents,
turn OFF the tool and disconnect its power supply after use. Clean, then store the tool indoors
out of children’s reach.
3. If the blade has become dirty, use a blade cleaner (not included) to clean it. Dirty blades will
bind easily, and will often overheat and burn the wood as it cuts. Overheated blades dull
more easily.
4. If the blade has become dull, replace it. Dull blades will cause increased tear-out and ragged
edges on the cuts.
5. Occasionally clean the Slides, rotating Table components and other moving parts. Use a good
quality dry lubricant (not included) which will not attract dust.
WARNING: If the supply cord of this power tool is damaged, it must be replaced only
by a qualified service technician.