WEN 70712 12 Sliding Compound Miter Saw - Manual (Page 12)

ITEM 70712 OPERATOR’S MANUAL 12
1. Be sure your extension cord is properly wired and in good condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
2. Protect your extension cords from sharp objects, excessive heat and damp or wet areas.
3. Use a separate electrical circuit for your tools. This circuit must not be less than a #12 wire
and should be protected with a 20 Amp time delayed fuse.
4. Before connecting the motor to the power line, make sure the switch is in the OFF position
and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
WARNING: This tool/equipment must be grounded while in use to protect the operator
from electrical shock.