Triton FT7000 EDU Installation Manual - Manual (Page 9)

9
M
oDEl
Ft7000 EDU a
ssEMbly
F
iElD
i
nstallation
G
UiDE
EDU Tray Assembly:
1. Refer to the Figure below. Fully extend the left and right hand slide rails (the right hand slide rail
is part of the UCV Vertical Assembly).
2. Refer to the Figure below. Place the EDU Tray Assembly between the slide rails so the horizon-
tal (front) and vertical (rear) mounting tabs on the tray are just behind the corresponding slots
on the slide rails.
3. Fit the (front) horizontal mounting tabs on the tray into the corresponding slots on the slide rails.
Pull the tray backward until the mounting tabs are fully engaged in the slots.
4. Fit the (rear) vertical mounting tabs on the tray into the corresponding slots on the slide rails.
Push the tray DOWNWARD until the mounting tabs are full engaged in the slots.
5. Secure the EDU Tray Assembly to the left and right slide rails with two (2) #8/32 x 3/8” screws.
EDU tray mounted
in the horizontal slot
EDU tray mounted
in the vertical slot
EDU t
ray
M
oUntED on
s
liDE
r
ails
s
liDE
r
ails
E
xtEnDED w
/
o
EDU t
ray
Vertical slide
mounting slot
Horizontal slide
mounting slot