Triton FT7000 EDU Installation Manual - Manual (Page 11)

11
M
oDEl
Ft7000 EDU a
ssEMbly
F
iElD
i
nstallation
G
UiDE
E-C
Hain
(C
ablE
t
raCK
)
i/o b
ay
(l
owEr
)
EDU
t
ray
UCv v
ErtiCal
a
ssEMbly
EDU Comms/Power
Cable and Clips
Cable Ty
Hangers
UCV Ground
Cable Connection
EDU Bin Present
Switch Cable
Installation of the EDU Mechanism on the Mounting Tray
M
oUntinG tHE
EDU M
ECHanisM
1. Set the EDU Mechanism on the tray (along the left side of the tray). This will help facilitate the
connection of the cables.
2. Refer to the Figures below. Plug the EDU Bin Present Switch cable (at the output of the E-Chain)
into the “Bins” connector at the EDU (at the forward edge of the EDU Driver PCB). The “Bins”
connector (on the EDU side) should be marked with a WHITE dot and the cable is labeled as
“ Bins”) .
3. The EDU Comms/Power cable is a bundle of two (2) cables (Power and Comms). Plug the
Power cable into the top connector on the rear edge of the EDU Driver PCB (If there is an ex-
tension cable plugged in at this location, plug the Power cable into the extension cable). Plug
the Comms cable into the connector that is third (3rd) from the top on the rear edge of the EDU
Driver PCB.
C
onnECtinG tHE
C
oMMs
/p
owEr
C
ablE to tHE
EDU
Power connection
at EDU
Comms connection
at EDU
EDU
Extension cable
for Power cable
edu
t
ray
edu
t
ray
C
onnECtinG tHE
b
in
s
witCH
C
ablE to tHE
EDU
BINS
Connection
4. Ty wrap any excess of the EDU Comms/Power cable to the inside right edge of the tray at the
provided tie down point (right side of the tray, neat the rear of the EDU Mechanism).
EDU Mechanism
Driver PCB