Triton RL5000 X2 Series User Manual - Manual (Page 24)

2 0
M
ODEL
RL5000 (X2) U
SER
M
ANUAL
5. Lift the cassette lid to expose the reject tray. Remove any rejected notes. Lift the reject tray to gain
access to the currency compartment.
Cassette opened.
6. Pull the packer plate to the rear of the cassette (away from the shutter) until it locks to the white packer
plate latch. It will be necessary to push down on the packer plate latch to lock the packer plate in place.
The packer plate will be held in this position until the lid is closed or the latch is released by pushing it
down. Be careful not to release the packer plate onto your fingers.
9. Place the currency into the cassette. Allow at least one inch of clearance between the packer plate
when it is fully retracted and the currency. This will allow the packer plate to compress the currency.
10. Release the packer plate and lower the reject tray and the lid. The cassette can now be removed from the
loading tray by sliding it away from the probes.
11. Verify that the cassette is primed! Be certain the “GREEN” indicator is showing in the window below
the key! Install the cassette into the dispenser by placing the cassette guides on the dispensers’ rails
and firmly pushing the cassette in until it locks
in place.
12. Close and lock the security container.
7. Count the number of bills that remain in the cassette, if any. Next, count the number of bills that are
being added into the cassette.
8. Add the number of bills being placed into the cassette to the number that remained. The “Total”
number of these bills will be entered in the “E
NTER
C
ASSETTE
Q
UANTITY
” option.
Note: You may wish to record the number of notes removed from the reject tray for use when balancing the
note tray against the cassette/day close records.