Spectra Precision Survey Pro CE v3.80 Ranger GPS Reference Manual - Manual (Page 25)

Survey Menu – RTK
25
1H[W ! : opens the final Base Setup screen. The final screen depends
on the base point you choose:
•
If the base point has existing geodetic coordinates, or if they can
be computed from 3D plane coordinates and the latest projection
solution, the final screen allows you to SET the receiver with the
known position.
•
If the base point does not have geodetic coordinates or if geodetic
coordinates cannot be computed for this point, the final screen is
used to GET an autonomous position and set the receiver.
Base Setup Two – SET
This final Base Setup screen is used to SET the known base position
in Survey Pro and in the receiver. This screen will open when the
base point has measured or computed geodetic coordinates in the job.
Base Point : displays the base point name
chosen in the previous screen.
Latitude : displays the current latitude for the
base point.
Longitude : displays the current longitude for
the base point.
Ellipse Height : displays the current ellipsoid
height for the base point.
%$&. : returns to the previous Base Setup
screen.
6(7 : sets the base position in Survey Pro and configures the receiver
to begin broadcasting differential corrections. When successfully
completed, the Current GPS Base information screen returns with
the new base station information.
Base Setup Two – GET and SET
This final Base Setup screen is used to GET an autonomous (here)
position from the receiver and to SET that base position in Survey
Pro and in the receiver. This screen will open when the point is a
new point in the job file, or, in Localization mode when this is the
first geodetic point in the job.