Spectra Precision Survey Pro CE v3.80 Ranger GPS Reference Manual - Manual (Page 24)

GPS Reference Manual
24
Base Height : displays the current height of the base point set in
Survey Pro.
Antenna : displays information about the antenna if it is available.
6HWXS : opens the Base Setup wizard where the base position can be
set and the receiver configured for RTK and post processing data
collection.
&OHDU : (visible only in Manual Entry mode) clears the existing base
setup so you edit the point if necessary.
Base Setup One – Pick Base Point
The first Base Setup screen is used to pick the base point and set the
antenna height.
Base Point : is where you enter the point name
that the base antenna is set up over.
Note: You can enter either an existing point
or a new point name into the Base Point
control. If you enter a new point name, the
routine will create a new point record in the job
file at the end of successful base station
configuration.
Antenna : displays antenna information defined from the Base
Receiver Antenna screen after tapping 6HWXS +5. The title of this
field changes depending on if the antenna has already been setup.
Measured : is where you enter the height of the antenna, measured to
the location specified on the Base Receiver Antenna screen.
6HWXS +5 : opens the Base Receiver Antenna screen (Page R-27)
where the details of the base antenna are defined.
Note: the antenna information and receiver serial number is stored
in the registry. When you setup the base or rover receiver and the
receiver serial number matches a number stored in the registry, the
associated antenna parameters are automatically recalled.