Spectra Precision ProFlex 800 Web Server - Manual (Page 39)

35
should be defined accordingly (port E, P or Q + message
type), namely the Differential Stream 1 is necessarily
associated with “Network 1” (or “NTRIP Server 1”) and
Differential Stream 2 with “Network 2” (or “NTRIP Server
2”).
Whereas the modem can only serve the “Network 1” or
“NTRIP Server 1” connection, the Ethernet port on the
other hand can serve both network connections, namely
port P for “Network 1”/“NTRIP Server 1” and port Q for
“Network 2”/“NTRIP Server 2”. Ports P and Q can not
only route their respective corrections (data streams) to an
external NTRIP caster, but also directly to the embedded
NTRIP caster, through two distinct mount points managed
by the caster.
• Programming the data generated by a base is addressed
separately (see Defining the Data Generated by a Base on
page 38 and Ethernet Data Streaming on page 51).
• Configuring a permanently operating reference station is
addressed in separate manuals (ProFlex 800 CORS
Getting Started Guide for the short version, and also the
CORS Station Chapter in the ProFlex 800 Reference
Manual).
General
Parameters
• Click on the Base Setup menu.
• Set the receiver parameters:
– Dynamic: Choose the type of motion that best suits the
base (static, quasi-static, walking, ship, automobile,
aircraft, unlimited, adaptive or user-defined).
Typically, a base is static.
– Moving Position: Enable this option if the base may be
moving while being operated. For all other cases where
the base always stays static, keep this option disabled.
– Latitude, Longitude, Ellipsoid Height: Use these three
fields only when the
Moving Position option is disabled.
Use them to enter the reference position of the base
(three-dimensional geographical coordinates). The
coordinates shown in these fields are irrelevant and not
used when the
Moving Position option is enabled.
Clicking on the Get current position button assigns the
last position computed by the receiver to the base as
its reference position. It makes no sense to use this
button when the
Moving Position option is enabled.
• Set the GNSS antenna parameters: