Spectra Precision ProFlex 800 Web Server - Manual (Page 28)

24
• At the bottom of the page, in the Differential Port pane,
select the Automatic option to let the receiver detect the
incoming differential stream automatically.
NOTE: Automatic is the recommended choice for the
Differential Port setting because in this case, you don’t
need to define the ports receiving the two possible
differential streams.
• Click on the Configure button to let the Web Server load all
your new parameters to the receiver. You just have now to
define the output messages (see Defining Output
Messages on page 30).
NTRIP Client Via
Modem
The internal modem should be configured first:
• Click on the Connections menu and then on the Bluetooth/
Modem sub-menu.
• Set the following parameters in the Internal Modem/Device
Settings pane:
–
Power: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual: The modem will be powered up only by going
through the
Connections > Bluetooth/Modem page and
setting the modem to “Power On” (or using the
$PASHS,MDM,ON command).
– Automatic Connection: Check this option.
– Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
– 2G Only: Recommended to save power.
• Set the following parameters in the Internal Modem/GPRS
Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):
Modem
RTK Corrections
ProFlex 800
NTRIP Caster
(Mobile Wireless
Communication)
Internet
IP address
or server name
(Client)