Seed Hawk Air Drill Monitor 2008 - Manual (Page 24)

Seed Hawk Air Drill Monitor
SeedHawk Manual 01.doc Not Released Page 22
4.4 Sensor Replacement
The monitor will alarm the operator if there is a faulty sensor in the system (see section on
Communication Alarms).
To replace a single faulty sensor, the replacement sensor is plugged into the harness prior to
turning on the system. When the power is turned on, the monitor will learn the new sensor and
replace the faulty sensor with it. This procedure will only work when there is one new sensor in
the system.
When more than one sensor is to be replaced, do a special startup (hold OK and DOWN) to
relearn the entire system.