Seed Hawk Ground Drive: Granular & Liquid 2011 - Manual (Page 57)

Seed Hawk
®
Manual Granular and Liquid Tanks Page 52
16. Refer to Section 8.4.2 to set your implement width.
17. Refer to Section 8.4.4 to calibrate your Ground Speed Sensor.
18. Refer to Section 8.4.5 to calibrate each of the meters installed on your
system.
19. System is ready for use.
8.4.1.3 ADD A SENSOR
To add a sensor, simply highlight the
sensor you would like to install.
Note: The sensor that you are trying
to install should read “None”. If the
highlighted sensor shows OK prior to
install, there is already a sensor
installed in this position. If this is the
case, please see section 8.4.1.4.
Go out on the implement and physically plug in the sensor.
Return to the Monitor. Press Install.
If the display shows “OK” next to the
sensor, the sensor has been
successfully installed.