Seed Hawk TOOLBAR 2014 - Manual (Page 10)

SEED HAWK ® 2014 TOOLBAR OPERATOR’S MANUAL SEED HAWK ® 2014 TOOLBAR OPERATOR’S MANUAL 12
2.9.2 Applied Safety Signs
CAUTION!
READ OPERATOR’S
MANUAL before
operating machine. Heed
all instructions before
operating machine.
WARNING!
HIGH PRESSURE
FLUID HAZARD.
Relieve pressure on
system before
disconnecting, repairing
or adjusting. Wear proper
hand and eye protection
when searching for leaks.
Keep all components in
good repair.
WARNING!
OVERHEAD WING
HAZARD.
Do not stand underneath
wings, during extending,
raising, or when in the
raised position.
Hydraulic leaks could
cause the wings to fall
unexpectedly. Keep others
away.
SH 200
SH 700
13
2.9.3 Safety Sign Information
Safety Sign Legibility: All safety signs applied to the implement must be
visible and legible. Keep dust and dirt cleared from safety signs and ensure that
visibility is not obscured.
Safety Sign Replacement: Replacement safety signs may be ordered through
your dealer or distributor. Contact Seed Hawk Inc. if unable to obtain replace-
ment safety signs from a dealer or distributor.
Damaged or Deteriorated Safety Signs: Remove and replace any safety
signs that have either been damaged or show signs of deterioration.
Safety Signs on Replacement Parts: Ensure that parts or components that
are replaced on the implement that had a safety sign attached originally include
a safety sign.
Affixing Safety Signs to Implement
1. Ensure proper position and orientation before installing.
2. Ensure installation area is clean and dry.
3. Ensure ambient temperature is above 50˚F (10˚C).
4. Remove backing material to expose label adhesive.
5. Place one edge of label to machine surface.
6. Slowly press the label onto the surface.
7. Ensure no air pockets become under surface of label.
DANGER!
ELECTROCUTION
HAZARD
Stay away from power
lines when transport-
ing, extending or folding
implement. Electrocution
can occur without con-
tacting power lines.
SH T2