Connecting the display cable – Seca 665 User Manual
Page 73
Before you really get started… • 73
English
Connecting the display
cable
ATTENTION!
Malfunction due to installation errors
If cables are strained during fitting, e.g. bent
tight or with plugs kinked, this may result in
faulty displays and failure of the display.
– Route all cables to prevent sharp bends and
kinked connectors.
– Provide strain relief by routing all cables in the
relevant holders.
1. Lift the scale so that the underside of the weighing
platform is accessible.
NOTE
You can rest the scale on the handrail for this
assembly work.
2. Pass the display cable along under the weighing
platform to the electronics box as shown in the
diagram.
3. Connect the display cable to the electronics box.
4. Push the cable clip attached to the display cable at
the factory into the bore on the scale frame until
you feel it engage.
5. Press the display cable into the cable clips on the
scale frame until you feel them engage.
6. Lower the scale.