LumaSense Technologies INNOVA 1316A-1 User Manual
Instruction manual
Table of contents
Document Outline
- Index
- 1316A-1 Multi Gas Monitor 4
- About this Manual 6
- Chapter 1 Introduction and Specifications 7
- Chapter 2 Installation and Getting Started 17
- Chapter 3 Configuration and displaying measurement results 34
- Chapter 4 Calibration 53
- Chapter 5 Maintenance 88
- 1316A-1 Multi Gas Monitor
- Safety Considerations
- About this Manual
- Chapter 1 Introduction and Specifications
- Chapter 2 Installation and Getting Started
- Chapter 3 Configuration and displaying measurement results
- Chapter 4 Calibration
- 4.1 Introduction
- 4.2 Zero Calibration and O2 Span Calibration
- 4.3 Span Calibration
- 4.3.1 Introduction.
- 4.3.2 Checking and Changing the Particle Filters
- 4.3.3 Calibration Gases
- 4.3.4 Connecting the Calibration Gas
- 4.3.5 Span Calibration
- 4.3.6 To perform a span calibration with single component gas.
- 4.3.7 To perform a span calibration with multi component gas mixture.
- 4.3.8 Installing a new NO sensor.
- 4.4 Reset Span Calibration
- Chapter 5 Maintenance