LumaSense Technologies M305 - Manual (Page 11)

M305 Manual Installation and Operation 11
3 Installation and Operation
3.1 Installation
Install the blackbody emitter in the desired location that preferably has no moving air near the
emitter aperture. The M305 has been factory wired to operate from your standard 100 to
120 VAC at 15 amps and requires approximately 1000 watts upon power up. Optional voltages
are available upon order. Check the specification label in the rear prior to applying power.
3.2 Operation
3.2.1 Starting Up
1. Allow the M305 to warm-up to room temperature for at least two hours after
unpacking and prior to applying power to remove any condensation.
2. Connect the power cable to a VAC service that matches the power requirement
specification noted in the Technical Data section and on the Specification Label
located on the rear of the M305.
3. Turn on the power switch/breaker and wait 20 seconds for the system to self test.
Warning: Do not connect or disconnect while power is on.
Using the front panel push buttons
PAGE Engages access to controller parameters. Do not alter any
configurations.
SCROLL Engages access to menu items underneath the Page menu.
No need to use this button.
UP/DWN Used to raise and lower the temperature setpoint.
3.2.2 Changing the Setpoint
Press the UP/DWN buttons as required to raise or lower the temperature setpoint. To change the
setpoint faster, hold the UP or DWN button in.
Eurotherm controller
BLACKBODY
TEMPERATURE
BLACKBODY
SETPOINT