Lincoln Electric IM571 RANGER 300 D and 300 DLX - Manual (Page 42)

CONNECTION DIAGRAMS F-2 F-2
RANGER 300 D AND 300 DLX
ELECTRODE TO WORK
14 PIN
TO WORK
AMPHENOL
N.A. USE POLARITY SWITCH TO SET FOR DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO A WIRE WELDING-CV POSITION.
WARNING
Keep guards in place.
or service this equipment.
Keep away from moving parts.
Only qualified personnel should install,use
CONTROL MODULE CONNECTION DIAGRAM
RANGER 300 DLX / LN-25 WITH K624-1 42 VOLT REMOTE OUTPUT
N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
6-20-97
Do not touch electrically live parts.
CABLE PLUG
CAUTION :
THE ENGINE WELDER OPERATING MANUAL.
PLACE WELDER TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.
APPLICATIONS. SEE OPERATING MANUAL.
N.D. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE OUTPUT CONTROL SWITCH IN "OUTPUT CONTROL REMOTE" POSITIION.
ELECTRODE CABLE
TO WIRE FEED UNIT
TO LN-25 INPUT
K626-XX INPUT CABLE ASSEMBLY
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
S23732-3
WARNING
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
ELECTRODE TO WORK
S23732-4
CAUTION :
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
THE ENGINE WELDER OPERATING MANUAL.
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
APPLICATIONS. SEE OPERATING MANUAL.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
N.B. USE POLARITY SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO A WIRE WELDING-CV POSITION.
N.D. PLACE IDLER SWITCH IN "HIGH" POSITION.
6-20-97
TO LN-7 INPUT
CABLE PLUG
14 PIN
AMPHENOL
OPTIONAL K857
REMOTE CONTROL
6 PIN
AMPHENOL
ELECTRODE CABLE
TO WORK
TO WIRE FEED UNIT
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
K584 CONTROL CABLE
RANGER 300 DLX / LN-7 CONNECTION DIAGRAM