Lincoln Electric IM626 Mobiflex 200-M Lamp Kit - Manual (Page 14)

C-1 MAINTENANCE C-1
LAMP OPTIONS FOR MOBIFLEX 200-M
ROUTINE MAINTENANCE
This product has been designed to function without
problems for a long time with a minimum of mainte-
nance.
CLEANING/REPLACING THE
SPATTER GUARD
A glass spatter guard is positioned in front of the long-
life halogen bulb to prevent spatter build-up on the
face of the bulb. When the spatter guard becomes
dirty with spatter and fume, it is necessary to clean or
replace it.
• Remove holding spring by squeezing on the loose
ends and pulling it out; the glass spatter guard will
drop out.
• Clean the spatter guard with glass cleaner or a mild
abrasive. If the glass becomes excessively dirty or
damaged, replace it.
• Wipe the lamp housing and the plastic face of the
halogen bulb with a soft, damp cloth.
• Replace the glass spatter guard over the bulb and
secure with the holding spring.
REPLACING THE HALOGEN BULB
When the halogen bulb burns out, it is necessary to
replace it.
• Disconnect from input power before servicing this
equipment.
• Have a qualified person install and service this
equipment.
------------------------------------------------------------------------
• Remove holding spring by squeezing on the loose
ends and pulling it out; the glass spatter guard will
drop out.
• Push on one of the side tabs (that hold the bulb in)
with a screwdriver until the bulb assembly pops loose.
• With one finger, push through the hole directly
behind the bulb to push the bulb assembly out the
front of the lamp housing.
• Detach the bulb from the cable base.
• Push new bulb onto cable base
(polarity doesn’t matter).
• Push bulb assembly back into lamp housing.
• Set the spatter guard back over the bulb and secure
with the holding spring.
WARNING