Lincoln Electric IM733 LN-15 WIRE FEEDER - Manual (Page 17)

B-5 OPERATION B-5
LN-15 ACROSS THE ARC MODEL
Rotate the WFS knob until the desired parameter is
displayed.
CV/CC Mode:
WFS Units:
2. Activate and release the GAS PURGE switch to
select the parameter. The present value will then
display in the right hand side of the display.
Example:
3. Rotate the WFS knob to change the parameter set-
ting.
CV/CC Mode:
• "CU" for Constant Voltage power sources
• "CC" for Constant Current power sources
WFS Units:
• "US" for in/min
• "Eur" for mm/min
4. Press the GAS PURGE switch to save the setting.
The LN-15 will then return to the original "Press
Spin" mode in step 1.
5. To exit the "Press Spin" set-up mode, turn off power
to the LN-15, or simply wait 15 seconds and the
LN-15 will enter normal operation.