Elitegroup L372N1 - Manual (Page 85)

appendix B agency regulatory notices
B-4
?? The cord set must have minimum rated current capacity of 7 A.
?? The attachment plug must be a two-pole, grounded type with a
Japanese Industrial Standard C8303 (15 A, 125 VAC) configuration.
Other Countries
?? The cord set fittings must bear the certification mark of the agency
responsible for evaluation in a specific country. Acceptable agencies
are:
BSI (UK)
OVE (Australia)
CEBEC (Belgium)
SEMKO (Sweden)
DEMKO (Denmark)
SETI (Finland)
EANSW (Australia)
SEV (Switzerland)
IMQ (Italy)
UTE (France)
?? The flexible cord must be of a HAR (harmonized) type HO5VV-F
3-conductor cord with a minimum conductor size of 0.03 square
inches.
?? The cord set must have a current capacity of at least 10 A and a
nominal voltage rating of 125 / 250 VAC.
CAUTION: MODEL L372Sxx FOR USE WITH POWER SUPPLY MODEL
LiShin LSE0110A21120
ATTENTION: MODEL L372Sxx, POUR UTILISER AVEC LE MODELE
LiShin LSE0110A21120
Laser Safety
The optical drive used with this computer is certified as a Class 1 laser
device according to the U.S. Department of Health and Human Services
(DHHS) Radiation Performance Standard and International Standards IEC
825 / IEC 825-1 (EN60825 / EN60825-1). The device is not considered
harmful, but the following precautions are recommended:
?? Do not open the unit.
?? Avoid direct exposure to the laser beam.
?? If the unit requires service, contact an authorized service center.