Elitegroup 223 - Manual (Page 4)

ii
Notices
Federal Communications Commission Radio Frequency
Interference Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed
and used in accordance with the instruction manual may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
¾ ¾ Reorient or relocate the receiving antenna.
¾ ¾ Increase the separation between the equipment and receiver.
¾ ¾ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
¾ ¾ Consult the dealer or an experienced radio TV technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. Shielded interface
cables and a non-shielded AC power cord must be used in
order to comply with emission limits.
This equipment is to be used with power supply:
I/P: 100-240 Vac, 50-60Hz, 1.5A
O/P: 20Vdc, 2.5A
There is no internal power supply.