Installing the touchpad driver, Installing vga display drivers, Manual installation – Elitegroup G220 User Manual User Manual
Page 66: Card reader driver

Installing the TouchPad Driver
Insert the CD-ROM Driver into your CD-ROM/DVD-ROM drive.
Click “Start” and Select “Run”.
Type the following:
D:\TouchPad\Win2KXP\Setup.exe (If D is not your CD-ROM/DVD-ROM drive, substitute
D with the correct drive letter).
Click on “Setup” to begin the Installation Wizard. Follow the Wizard’s on-screen instructions
to complete the installation.
Restart the system.
Installing VGA Display Drivers
Insert the CD-ROM Driver into your CD-ROM/DVD-ROM drive.
Click “Start” and Select “Run”. Type the following: D:\Driver\VGA\Setup.exe (If D is not
your CD-ROM/DVD-ROM drive, substitute D with the correct drive letter).
Click on “Setup” to begin the Installation Wizard. Follow the Wizard’s on-screen instructions
to complete the installation.
Restart the system.
Manual Installation
To install the driver manually, follow the step-by-step procedures described on each individual
section for a more clear installation.
Card Reader Driver
For Service Pack 1: If you are using the Microsoft’s Service Pack 1, the SD Card Driver is
not included in the package so recommend you to follow the procedures mentioned on the
next topic of “Installing the CardReader for SD Card Driver”.
For Service Pack 2: There is no need to install the SD Card Reader driver since it is now
included in Service Pack 2.
58