Elitegroup A900 (V2.1) - Manual (Page 67)

1.
2.
3.
4.
1.
2.
3.
4.
Insert the CD-ROM Driver into your CD-ROM drive. Click
“Start” and Select “Run”.
Type the following: D:\Driver\IR Driver\SETUP.exe (If D is not
your CD-ROM drive, substitute D with the correct drive letter).
Click on “Setup” to begin the Installation Wizard.
Follow the Wizard’s on-screen instructions to complete the
installation. Restart the system.
Manual Installation
To install the driver manually, follow the step-by-step procedures
described on each individual section for a more clear installation.
Installing the IR Driver for Win98SE
Please follow these instructions to install the FIR driver:
From your screen, click on the "My Computer" icon and use your
mouse or touchpad right button to select the "Properties" item.
Select the “Device Manager” and click on the "Winbond Infrared
Controller" (denoted by a yellow mark symbol).
Click the "Update Driver" tab and select the "Search for a better
driver than the one your device is using now(Recommended)"
item and specify a location.
Select the "Browse" button from the "Include this location in the
search" and specify for the designate location of your CD driver.
For Win2K/XP
After the installation of the IR is completed, the device name
found on your system is "Winbond Fast Infrared Controller
(DMA)".
Double click on the item and select the "Advanced" tab. From the
"Value" box, select the "TEMIC" item and click on the "Apply"
button.
For Win98SE/ME
53