Elitegroup A900 (V2.1) - Manual (Page 62)

OnBoard Parallel Port
This option specifies the base I/O port address of the parallel port on
the motherboard.
The settings are Auto (default value), Disabled, 378h,
278h, or 3BCh.
Parallel Port Mode
This option specifies the parallel port mode.
The settings are Normal, Bi-dir (default value), EPP or
ECP.
Parallel Port IRQ
This option specifies the IRQ used by the parallel port. This is only a
display-only item and cannot be altered.
The settings are 5 or 7 (default value).
Parallel Port DMA Channel
This is only a display-only item and cannot be altered.
Change Supervisor Password
This field allows you to set the Supervisor password. To set the
Supervisor password, highlight this field and press the [Enter] key.
The following dialog box appears:
Enter new supervisor password:
Auto Configuration with Optimal Settings
The optimal default settings are best-case values that should optimize
system performance. To set the configuration, highlight this field and
press the [Enter] key. The following dialog box appears:
48