DataComm 45-0031-WH Recessed Low Voltage Media Plate with Duplex Receptacle - Manual (Page 4)

Installation / Instruction Sheet 45-0041-WH (Continued)
Remember in the event your surge unit alarm sounds, simply remove the
replaceable SurgeBloc
® . The receptacle still functions as a normal duplex
receptacle without surge protection. The Replacement SurgeBloc ®
module #1209 made by Cooper Wiring Devices can be ordered through a
DataComm Electronics distributor, your local electrical distributor or
contact Cooper Wiring Devices’ Sales Department at 800.441.3177 or
45-31 Court Square, Long Island, NY 11101.
WARNING
 DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction
sheets.
 Instruction sheets are available online at www.datacommelectronics.com.
CAUTION
 For shock protection, this device must be properly grounded.
 Use copper wire only with this device.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.
 Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near
a swimming pool.
 SAVE THESE INSTRUCTIONS.
Surge Suppressor Specifications
Clamping Response Time: 1 Nanosecond
2-Pole 3-Wire
Grounding
60 Hz Receptacle
1875W
Total Maximum
Surge Dissipation
Maximum Surge
Current
Peak Suppression
Voltage
Surge Protection
Replacement
Module
15A-125V
1875W
340 Joules 12,000 Amps 1,000 Volts
Hot/Neutral,
Hot/Ground,
Neutral/Ground
# 1209
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
Removing the SurgeBloc ® Module
888.223.7977
www.datacommelectronics.com
1/5/11 Rev. 2 Page 2 of 3