DataComm 45-0014 Cable Plate with Flexible Opening, 1-Gang - Manual

2-1/4”
Parts Included Tools Needed
1. Cable Plate with Flexible Opening, 1-Gang 1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use the Cable Plate with Flexible Opening to install low voltage cables behind
your flat panel TV, (see Figures 2 & 3), your amplifier or other audio and video devices.
This wall plate is designed for use with Low Voltage / Data Cables “ONLY”.
The Cable Plate with Flexible Opening is designed with the low voltage mounting brackets molded to the back of the plate (see Figure 1).
Determine the location of your flat panel TV, amplifier or audio/video device. Use the enclosed template to cut a hole in the drywall. When cutting the
hole in the drywall, allow for the location of the stud. Now simply pull your audio/video cables through the wall and through the opening in the Cable Plate
with Flexible Opening. Now insert the Cable Plate with Flexible Opening flush into the wall. Next, screw down the wall plate screws with wings. The
wings will fasten tightly against the back of the drywall (see Figure 3) and your installation is complete.
This Cable Plate with Flexible Opening is Designed for Use with Low Voltage / Data Cables “ONLY”.
Do Not Run or Pull the TV Cord or Other Electrical Cords Inside the Drywall.
National Electrical Code (NEC) Does Not Allow the Installation of the TV Power Cord or an Extension Cord Behind the Wall.
CAUTION
 Never install low voltage wiring during lightning storms.
 Never install low voltage wiring in wet locations unless the wire is specifically designed for wet locations.
 Never touch un-insulated low voltage wires or terminals unless the wire has been disconnected at its source.
 Use caution when installing low voltage cables.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warning and instructions marked on the product.
 Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
 SAVE THESE INSTRUCTIONS.
Figure 2 - Front View
Instruction / Installation Sheet
DataComm Electronics Easy Mount Series
45-0014 Cable Plate with Flexible Opening, 1-Gang
This product is patent protected
by U.S. Patent number 7495171
RoHS Compliant
2/8/12
Figure 1
Figure 3 - Back View
45-0014 – Front View 45-0014 – Back View
4”
CUT ALONG DOTTED LINE 
TEMPLATE
45-0014
Cable Plate with
Flexible Opening
1-Gang
ACTUAL SIZE
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector
Flat Screen TV
Flat Screen TV
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector
Using
Template,
Cut a Hole
in the Drywall
Low Voltage
Mounting
Bracket Wing