beautypg.com

DataComm 45-0070 7.2 Surround Sound 2-Gang Plate User Manual

DataComm Home Theater Systems

background image











Specifications:

Dimensions

4.8”W x 4.8”H x 1.1”D (12.2 x 12.2 x 2.8 cm)

Weight

0.7375 lbs. (11.8 oz)

Connectors

(14) 4-Way Push-Pin Post

(2) RCA-F Connectors

Plate

2-Gang Standard (U.S.)



Wiring Instructions:

To ensure the highest quality audio performance, use the proper gauge
of wiring based on length of each wire. Review the following table for
general recommendations or contact the speaker manufacturer.

Wire Length

Minimum Gauge

10’ to 100’

16

100’ to 200’

14

Over 200’

12



It is important to leave enough excess wiring in the wall to help reduce the amount of tension to each termination. Keep speaker wires
and RCA cables away from AC wiring. If these wires must occupy the same area, keep them as far apart as possible and have them
cross at a right angle when crossing is necessary.


Plate Connections:

1. When

making

any

connections, confirm all the equipment is turned off.

2. When inserting any wires or connectors, be sure that they don’t bridge over to another terminal or wire, causing a short.
3. Typically one conductor is marked in some way, either with printing on the outer jacket, different color of wire, formed ridge on

the outer jacket or a thread within one of the conductors. The marked conductor should always be considered as the
positive/hot lead (RED).

4. It’s extremely important to maintain phasing by ensuring positive leads are connected to the positive terminals and the

negative leads are connected to the negative terminals on every component. If speaker wires are cross-wired, there will
typically be a lack of bass response and the audio may drift between the speakers rather than precisely placed.

5. Simply compress the push-pin terminal and feed the wire through the eye and release. The self adjusting tension will ensure

permanent and reliable conductivity.



Pin Connection

Compress and hold the connector, insert the pin into the side hole and release.

Banana Plug Connector

Insert the banana plug as far as it will go into the top hole of the push-pin terminal.

Bare or Tinned Wire

Strip the insulation off the speaker wires, exposing approximately ½ inch (14mm) of bare

wire. Individually twist each conductor to keep the strands together. Compress and hold the

connector while threading the wire into the side hole and release.


RCA Connector

The RCA connectors for powered/active subwoofers utilize “F” type connectors on the back

of the plate for increased reliability. Be sure the left and right remain consistent throughout the

wiring

process.

DataComm Electronics, Inc.
5875 Peachtree Industrial Blvd.
Suite 260
Norcross, GA 30092-3677
888.223.7977
770.662.8205
www.datacommelectronics.com

Instruction / Installation Sheet

DataComm Electronics 45-0070 7.2 Surround Sound 2-Gang Plate

DataComm Electronics’ newly designed home theater plate is a 2-gang, in-wall connection plate
designed to allow a concise hookup of all speakers in a premium 5.1, 6.1, or 7.1-channel
surround sound system. It includes terminals for up to seven (7) speakers, and two (2)
powered/active low level subwoofers. The heavy-duty plate supports the weight of high quality
wires and clearly identifies each connection point. The gold plated push-pin design
automatically adjusts to wire size and environmental conditions, ensuring the highest
performance for your audio needs. This product will accept wire up to 12 gauges in thickness,
pins and single or double banana plugs. The powered subwoofer connections use RCA to F
connectors. Confirm you are using approved connectors for audio and low voltage in your area.

10/8/08