DataComm 45-0028-WH Recessed Pro-Power Kit - Manual (Page 5)

Use the
Recessed Pro-Power Kit with Duplex Surge Suppressor to install power and low voltage cables behind your flat panel TV, amplifier or other audio
and video devices to your equipment room or at the location of your head end equipment (see Figures 1 & 2).
IMPORTANT INSTRUCTIONS:
 Use the local electrical code approved installation when installing this product.
 The electrical parts in this kit are designed to be used only as a kit and none of these electrical parts are designed to be used individually.
 This product is not designed to be part of your home or a commercial building’s electrical wiring system.
 This installation is only energized (electrically active) when the supplied 6 ft. cord is plugged into the recessed straight blade inlet located on the
recessed low voltage cable plate and the straight blade end of the 6 ft. cord is plugged into either your surge protector or wall receptacle.
If you are not familiar with home wiring systems, please call a qualified electrician to install this product.
IMPORTANT INSTRUCTIONS:
This product is designed for retrofit work only because the electrical outlet box cannot be attached to a stud.
This product is designed to alert you if you ever lose surge protection. The Surge Suppressor Receptacle is designed to provide protection against short-
term over-voltage conditions as well as from RFI (radio frequency interference). The Surge Suppressor cannot survive, or provide protection in the rare
event of a direct lightning strike on the service power line.
The Surge Suppressor alerts you to the failure of the surge protection component by means of
an audible signal. If alarm sounds, device has “received” power surges in excess of its capacity and is no longer functioning as a surge protector. To shut
off alarm, simply turn the “Alarm Off” screw on the front of the receptacle clockwise. Note: When alarm sounds and the “Alarm Off” screw is turn off, the
receptacle still functions as a normal duplex receptacle without surge protection.
Installation Instructions for Retrofit Only:
Select the location of your flat panel TV mounting bracket. Now select the location for both the wall plates for the Recessed Pro-Power Kit with Duplex
Surge Suppressor.
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Tools Needed:
1. Drywall
Saw
2. 6 Ft. Tape Measure
3. Pencil
4. Screwdriver
Instruction / Installation Sheet
DataComm Electronics 45-0028-WH Recessed Pro-Power Kit with Duplex Surge Suppressor
Parts Included:
1.
Recessed Low Voltage Mid-Size Plate with Duplex Surge Receptacle
2. Recessed Low Voltage Cable Plate with Straight Blade Inlet
3. Two (2) Electrical Outlet Boxes
Four (4) Screws per Outlet Box
4. 15 Amp/125 Volt Duplex Surge Receptacle
5. Three (3) Wire Nuts
6. 6ft. 16/2 with Ground Cord Set with 360 o Rotating Head
Figure 1 – Front View Figure 2 – Back View
Page 1 of 4 10/1/12