beautypg.com

Normal operation, Warning – Condec DPDG User Manual

Page 7

background image

6

gauge. By setting a factor of 25, a 40 PSI pressure would display

as 1000 (40 x 25). The engineering unit displayed on the

CONDEC DPDG will be “Cust”.

Normal Operation

Turning the backlight on and off:

Press the ENTER button.

Zeroing the display: Press and hold the ZERO button.

MAX/MIN: The CONDEC DPDG stores minimum and maximum

pressure values in memory. Pressing the MAX/MIN button once will

display the minimum pressure from memory. Pressing the MAX/MIN

button again will display the maximum pressure from memory. After

about 2 seconds, the gauge returns to normal (live display) operation.

To clear the MAX/MIN memory registers, press and hold the MAX/MIN

button for 2 or more seconds until “CLr” is displayed.
The analog bar graph at the bottom of the display indicates the applied

pressure level relative to the full range of the gauge. Keep in mind that

if a TARE value has been programmed into the gauge, the displayed

pressure will not reflect the true pressure applied.

Changing the Batteries

WARNING

Explosion hazard

Batteries must only be changed in an area known

to be non-hazardous.

Grasp the face ring on the CONDEC DPDG, turn it approximately ¼

turn counterclockwise and remove. The face of the gauge can now be

lifted to expose the battery holder. Take off the battery hold clip and

remove the batteries. Install three AA batteries noting proper polarity.

Note: Use

ONLY AA size batteries and be sure to reinstall the battery

holder retaining clip. Reassemble the case making certain that the face

is properly oriented.
If you purchased the optional 24 Volt powered version, the terminals for

power input are located on the rear of the gauge. To apply power

simply connect 24 volts to the rear terminal block taking care to

observe proper polarity.