Introduction – Condec DPDG User Manual
Page 2

1
Introduction
The CONDEC DPDG combines the high accuracy of digital electronics
with the convenience and ease of use of an analog test gauge.
Accurate to ± 0.05% FS, the CONDEC DPDG can be used as a
calibration reference, or in any application where high accuracy
pressure measurement is required.
Many user configurable functions have been designed into the
CONDEC DPDG including sampling rate, TARE, damping, auto shut
off, and min-max. Once the gauge is configured, settings can be
locked and password protected to prevent unauthorized changes to
configuration.
1.1 Customer Service
(888) 295-8475
www.4condec.com E-mail: [email protected]
1.2 Standard Equipment
Check to see that your CONDEC DPDG has arrived intact. Batteries
are factory installed unless you have purchased the optional 24V
powered version, in which case batteries are not supplied or installed.
Save the packing materials at least until you have verified that there is
no concealed damage.
1.3 Safety information
A Warning identifies conditions and actions that pose hazard(s) to the
user; a Caution identifies conditions and actions that may damage the
Calibrator or the equipment under test.
Symbols Used
The following table lists the International Electrical Symbols. Some or
all of these symbols may be used on the instrument or in this manual.