Brocade 6505 Hardware Reference Manual - Manual (Page 25)

Setting time zones
You must perform the procedure on all switches for which the time zone must be set. However, you only
need to set the time zone once on each switch, because the value is written to nonvolatile memory.
Use one of the two following procedures to set the time zone. The first procedure requires you to select
the actual time zone and the second requires you to select the country location of the switch.
The following procedure describes how to set the current time zone to Central Standard time using
timezonename mode.
1. Log in to the switch using the default password (which is password).
2. Enter the tsTimeZone command as follows:
Use timezonename to set the time zone by time zone ID, such as PST or Country/City.
The following example shows how to change the time zone to US/Central. The tsTimeZone
command by itself display the current time zone.
switch:admin> tstimezone
Time Zone : US/Pacific
switch:admin> tstimezone US/Central
switch:admin> tstimezone
Time Zone : US/Central
The following procedure describes how to set the current time zone to Pacific Standard Time using
interactive mode.
1. Enter the tsTimeZone command as follows:
switch:admin> tstimezone --interactive
You are prompted to select a general location from a list.
Please identify a location so that time zone rules can be set correctly.
2. Enter the appropriate number from the list that appears or Ctrl ‐D to quit.
3. At the prompt, select a country location from the list.
4. At the prompt, enter the appropriate number from the list to specify the time zone region or Ctrl
‐D
to quit.
Synchronizing local time using NTP
Perform the following steps to synchronize the local time using NTP.
1. Log in to the switch using the default password(which is password).
2. Enter the tsClockServer command:
switch:admin> tsclockserver ""
In the syntax ntp1 is the IP address or DNS name of the first NTP server, which the switch must be
able to access. The value ntp2 is the name of the second NTP server and is optional. The entire
operand "" is optional; by default, this value is LOCL, which uses the local clock of the
principal or primary switch as the clock server.
switch:admin> tsclockserver
LOCL
switch:admin> tsclockserver "132.163.135.131"
switch:admin> tsclockserver
132.163.135.131
switch:admin>
Setting time zones
Brocade 6505 Hardware Reference Manual 25
53-1002449-04