Standalone installation for a brocade 6520, Rack installation for a brocade 6520, Brocade 6520 configuration – Brocade 6520 Hardware Reference Manual User Manual
Page 22: Providing power to the switch
10
Brocade 6520 Hardware Reference Manual
53-1002705-02
Standalone installation for a Brocade 6520
2
Standalone installation for a Brocade 6520
Perform the following steps to install the Brocade 6520 as a standalone unit.
1. Unpack the Brocade 6520 and verify the items listed on
“Items included with the Brocade
on page 5. Verify the items are present and undamaged.
2. Apply the adhesive rubber feet. Applying the rubber feet onto the switch helps prevent the
switch from sliding off the supporting surface.
a. Clean the indentations at each corner of the bottom of the switch to ensure that they are
free of dust or other debris that might lessen the adhesion of the feet.
b. With the adhesive side against the chassis, place one rubber foot in each indentation and
press into place.
3. Place the switch on a flat, sturdy surface.
4. Provide power to the switch as described in
“Providing power to the switch”
ATTENTION
Do not connect the switch to the network until the IP address is correctly set. For instructions on how
to set the IP address, refer to
Rack installation for a Brocade 6520
Follow the installation instructions shipped with the appropriate rack mount kit:
•
Fixed Rack Mount Kit Installation Procedure
•
Mid-Mount Rack Kit (Switch) Installation Procedure
•
Slide Rack Mount Kit Installation Procedure
Brocade 6520 configuration
Once you have set up the Brocade 6520 in a rack or as a standalone switch, it is time to give it
power and a basic configuration. If you are going to use the Brocade 6520 in a single-switch setup,
you can use EZSwitchSetup to complete the basic configuration.
Refer to the EZSwitchSetup CD, included with the Brocade 6520, for more information. You can
also use the Brocade 6520 EZSwitchSetup Quickstart Guide.
If you do not want to use EZSwitchSetup, follow the instructions in the rest of this section.
Providing power to the switch
Perform the following steps to provide power to the Brocade 6520.