Installing an sfp+ module – Brocade FCoE Switch Module for IBM BladeCenter Installation and User’s Guide User Manual
Page 30
16
Brocade FCoE Switch Module for IBM BladeCenter: Installation and User Guide
CAUTION
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A` Laser de Classe 1
Installing an SFP+ module
The SFP+ module provides two fiber-optic cable connectors for connecting to external ports. To
install an SFP+ module, complete the following steps:
1. Read the safety information that begins on
and
2. If you have not already done so, touch the static-protective package that contains the SFP+
module to an unpainted metal surface of the BladeCenter chassis or an unpainted metal
surface on any other grounded rack component in the rack in which you are installing the
switch module for at least 2 seconds.
3. Read the information in
4. Remove the SFP+ module from its static-protective package.
5. Remove the protective insert, if one is installed, from the port where you are installing the
SFP+ module and store it in a safe place.
6. Remove the protective cap from the SFP+ module and store it in a safe place.
ATTENTION
To avoid damage to the cable or the SFP+ module, make sure that you do not connect the fiber
optic cable before you install the SFP+ module.
7. Insert the SFP+ module into the SFP+ module port until it clicks into place.