Anthro Elevate II Adjusta Assembly Instructions - Manual (Page 7)

Elevate II Adjusta Assembly Instructions 7
M6-20 Cap Screw
325-5272-00
STEP 9 - INSTALL FEET
ƒ Align one foot with each leg so the wheels are at the back. Attach the foot to
the leg with four M6x20 Socket-head Screws using the Anthro driver. Repeat
for the other foot.
ƒ With the help of another person, carefully rotate the table onto its feet.
STEP 8 - ATTACH ADJUSTA MECHANISM TO KEYBOARD SURFACE
ƒ Slide the Keyboard Surface under the mechanism arms. Align the three holes
on each end of the Keyboard surface with the three holes on each mechanism
arm. Secure the arms to the Keyboard Surface with six 1" Button-head Screws.
ƒ Position the Paddle on the Keyboard Surface so the four holes on the Paddle
align with the four holes on the Keyboard Surface and the brake cable runs
under the Adjusta Bar. Secure the Paddle to the Keyboard Surface with four 1"
Button-head Screws.
ƒ The keypad can be installed on the left or the right.
Choose a location, just remember that the table's upside
down now, so when you flip the table over, the keypad
will be on the opposite side. Align the keypad and its housing
with the four pre-drilled holes at the front of the keyboard surface so the
buttons are face-down at the front edge of the keyboard surface and the flat
side of the housing is against the shelf. Using four Phillips Head Screws, attach
the keypad and its housing to the front of the worksurface.
1” Button Hd PB Screw
325-5580-00
3/4” Phillips Screw
325-5370-00
Keypad and Slider
CONGRATULATIONS! YOUR ELEVATE II ADJUSTA ASSEMBLY IS COMPLETE!
RATINGS
Electrical Rating
ƒ Voltage rating: 120Vac, 60 Hz. When desk is moving with rated load: 400W. When desk is not moving: less than 100mW.
Temperature Ratings
ƒ Ambient temperature: 41 degrees F to 140 degrees F. Storage temperature: -4 degrees F to 158 degrees F.
ƒ Acclimate table to ambient temperature before use.
Load Rating
ƒ Elevate II Adjusta has a weight capacity of 150 lbs of distributed load on the back monitor surface and 40 lbs of
distributed load on the front keyboard surface.
Duty Cycle
ƒ Elevate II Adjusta has a 10% duty cycle. This provides 6 minutes of movement per hour or two minutes of continuous use
at full load. Once the table reaches its duty cycle, the table shuts down to cool; this usually takes about 20 minutes. Duty
cycle is reduced when the load exceeds approved weight limit or temperature is outside the stated range.