Anthro Chromebook Charging Cart Owners Manual - Manual (Page 3)

Questions? 1-800-325-3841
anthro.com 3
Getting Started, continued.
Loading Devices, Cable Management
NOTE: In the front User area, each shelf has 12 bays with 14 dividers.
The space behind the door latch pillar is not used.
Starting at the outside of each shelf, route one charging cord along
the top of each divider. Make sure that the cord end that goes into
the devices is at the front of the cart and that the power end goes
through the back panel and into the IT area.
Leave enough slack in front (approximately 4.5”; use the height of
the divider as a measuring stick) so users can plug in the device
without straining the cord. [Image A]
Weave the cord around the short hook at the front of the divider,
then back and forth through the three long channels along the top
of the divider, including the center channel that’s lower than the
others, and finally through the short hook at the back of the divider.
[Image B and C]
Feed the rest of the cord into the IT area. [Image D]
From the front of the cart, give a gentle tug on the cord to make
sure it’s held in place. If it’s loose, then the cord isn’t fully inserted
into each channel.
In the back IT area, poke cable clips into the holes in the pegboard
divider and route cords. Plug in each power adapter, then connect
each cord to an adapter.
For devices with large power adapters, first bundle the cord and
adapter together to save space, then plug in the adapter. Finally, use
cable clips to secure the bundle to the pegboard divider.
Turn the power switch to the OFF position before plugging the cart
into the wall.
A
B
C
D