Anthro Advanced Netbook Charging NCC10 Owners Manual - Manual (Page 4)

Anthro Netbook Charging Cart Owners Manual
Anthro ® Corporation Technology Furniture ® 10450 SW Manhasset Drive Tualatin, Oregon 97062 anthro.com 4
Loading Your Notebooks into the Cart
1. Open a door by pulling the latch handle out from the recessed area. Turn it 90 degrees and open.
2. Locate the external control switch. Push the switch to the middle position. When in the middle position,
power is cut off from both internal and external receptacles. To eliminate any arcing, the switch should
be in the off position when laptop charging units are being plugged in or removed from the storage bays
and prior to plugging the storage cart into a wall receptacle.
3. Plug in the power cord.
4. Load one notebook into each storage bay so that the power connection on each notebook faces out.
5. Insert one plastic cable clip into the hole on the side of each bay. Use this clip to hold the power cord in
place as shown.
6. Place each power transformer on the back shelf and route the cord from there to the notebook at the front
of the cart.
7. Load notebooks into bays on the other side of the cart.
NOTE: Make sure the external control switch is in the middle off position and then plug each notebook into the 120 V
receptacle in each bay.
Charging Your Notebooks
Push the external electrical switch into the down position to direct power to the receptacles inside the cart. Plug the
notebook power adapters into the receptacles to charge your notebooks. When the external switch is in the down
position, the external electrical receptacles do not receive power.
Using the Outside Electrical Receptacles for a Lecture Station
The cart can be used as a lecture station and has 120 V convenience outlets located on the outside of the unit. The
NCC10 has two external outlets, and the NCC20 has four external outlets. The maximum electrical output for the
combined external receptacles is 12 A. The external electrical receptacles are disabled when the cart is charging
notebooks.
1. Push the external control switch to the up position. You will feel a positive engagement of the switch
indicating power to the external receptacles. When the external switch is in the up position, the internal
electrical receptacles do not receive power.
2. Route cords and cables through the cord pass-through at the top of the cart to reach the Plug in your
other hardware such as printers and overhead projectors to use the cart as a lecture station.
Moving Your Cart
1. Your cart comes equipped with two swivel lock casters (they have a green tab) and two total lock casters
(they have a black tab). To successfully steer your cart, make sure the tabs on the locking casters are in an up-
right unlocked position. Push the tabs on the directional casters to the down position.
2. To protect the cart’s contents and structural integrity, make sure the doors are closed and latched before
moving the cart.
3. When you reach your desired location, push all the tabs on the casters to the down locked position.