NcSTAR VEVOFP62450G - Manual (Page 3)

3
Your VISM Scope is factory set with a Centered Reticle necessary for efficient sighting-in. If you
have made any prior adjustments to the Elevation and Windage settings it will be necessary to re-center
the reticle. Turn the Elevation Adjustment Dial in either direction until it comes to a complete stop. Next,
turn the dial in the opposite direction, counting the number of clicks, until you have reached the limits of
the adjustment range. Divide the number of clicks in half, and turn the dial that exact number of clicks
back towards the center of the adjustment range. Repeat this procedure for the Windage Adjustment Dial.
The reticle is now centered.
Focusing Your Scope
CAUTION: VIEWING THE SUN WITH THIS SCOPE OR ANY OTHER OPTICAL DEVICE CAN CAUSE
PERMANENT INJURY TO THE EYE INCLUDING BLINDNESS
Holding the scope at the proper distance from your eye, in order to achieve a Full Field of View, the
reticle should appear sharp and clear. If not, it will be necessary to adjust the focus by turning the Quick
Focus Ring.
1. Make quick glances through the eyepiece at a featureless bright surface such
as a white wall, or the open sky.
2. Turning the Quick Focus Ring counter-clockwise () will extend the Ocular
Lens outward, generally suitable for those who are far sighted. Turning the
Quick Focus Ring clockwise () will draw the Ocular Lens inward, generally
suitable for those who are near sighted.
3. Fine tune your adjustments until the reticle appears sharp and clear. Once
the Ocular Lens reaches its outer limits of adjustment, be sure not to force it
as doing so will cause damage to the eyepiece.
Magnification Adjustment
The EVO Scopes have a Magnification Power selector ring located directly in front of the eyepiece.
By turning this ring you can quickly and easily choose the desired magnification level. Lower levels of
magnification provide you with a wider Field of View, while higher levels of magnification provide you with
a closer view of your target.
CAUTION: DO NOT ATTEMPT TO LOOSEN OR REMOVE THE SLOTTED SCREW ON THE
MAGNIFICATION RING. DOING SO CAN RELEASE THE INTERNAL NITROGEN GAS CAUSING
DAMAGE TO THE SCOPE.
Side Parallax Adjustment Dial
On a few select EVO scope models will have a side Parallax Adjustment Dial feature. If your scope
is equipped with a side Parallax Adjustment feature, there will be a third turret dial on the left side of the
scope body, along with the elevation and windage turrets. The Parallax Adjustment Dial will fine tune the
parallax alignment of the scope, so that you can properly adjust the parallax of your reticle to the target
image in the scope.
B. Quick Focus Ring