NcSTAR APRLSG User Manual
Green laser with weaver style, Mount
GREEN LASER WITH WEAVER STYLE
MOUNT
This Green Laser is designed to mount directly to your firearm as an advantage of
quick target acquisition. Use of the laser will not replace the use of other sighting
devices in regards to accuracy, but it will certainly aid in locating your target
with ease.
This Green Laser mounts easily to almost any Picatinny or weaver style base in
any configuration that you choose.
Included in the package are two types of switches: a standard on & off cap
switch(4), and a coil pressure momentary type switch(10). Also included is the
specially designed weaver style mount(1), two different allen wrenches, and a
CR123A battery.
Always be sure that the unit is off when not in use to preserve battery life.
DANGER:
AVOID DIRECT EYE EXPOSURE TO LASER BEAM. LASER RADIATION IS
EMITTED FROM THE APPERTURE.
MOUNTING:
CAUTION: BEFORE BEGINNING INSTALLATION OF YOUR GREEN
LASER BE SURE THAT THE FIREARM IS UNLOADED. ALWAYS
PRACTICE SAFE FIREARMS HANDLING PROCEDURES.
Your new Green Laser is designed to mount directly to just about any weaver style or
Picatinny rail. To install, first loosen all three main mounting screws(2) using the provided allen
wrench. Next, the laser must be positioned so that the unit is right side up. To perform this
operation, remove the cap on the front of the laser housing(3) by twisting it counter
clockwise. Locate the reference leveling arrows(5) on the face of the laser. The arrow
pointing to the “U” is the arrow that should be pointing straight up. Twist the entire laser unit
within the mount(1) to get it square. When the arrows(5) are perfectly square up and to the
right you have successfully aligned your laser. Next, place the laser and mount(1) unit onto
the weaver style/Picatinny base of your firearm. The mount is equipped with a removable
recoil lug(11) to provide strength and stability to the mounting connection. Once you have
the mount(1) in the desired position, it is now time to tighten all of the mounting screws(2).
Be sure not to over tighten the mounting screws(2) to avoid stripping them. Also, be sure that
the mounting location for the laser allows for proper function and movement all of parts of
the firearm.