NcSTAR ARLSG User Manual
Green laser with universal barrel mount
GREEN LASER WITH UNIVERSAL BARREL MOUNT
This Green Laser is designed to mount directly to your firearm as an advantage of
quick target acquisition. Use of the laser will not replace the use of other sighting
devices in regards to accuracy, but it will certainly aid in locating your target
with ease.
This Green Laser mounts easily to almost any size barrel with two different sized
mounting screw sets.
Included in the package are two types of switches: a standard on & off cap
switch(4), and a coil pressure momentary type switch(10). Also included is the
specially designed Universal Barrel Mount(1), two different allen wrenches, and a
CR123A battery.
Always be sure that the unit is off when not in use to preserve battery life.
DANGER:
AVOID DIRECT EYE EXPOSURE TO LASER BEAM. LASER RADIATION IS
EMITTED FROM THE APPERTURE.
MOUNTING:
CAUTION: BEFORE BEGINNING INSTALLATION OF YOUR GREEN
LASER BE SURE THAT THE FIREARM IS UNLOADED. ALWAYS
PRACTICE SAFE FIREARMS HANDLING PROCEDURES.
Your new Green Laser is designed to mount directly to just about any barrel. To
install, first loosen the Laser Mount Screw(2) on bottom of the Universal Barrel
Mount(1) using the provided allen wrench. Next, place the Laser into the mount as
shown in the Front View. The laser must be positioned so that the unit is right side up.
To perform this operation, remove the cap on the front of the laser housing(3) by
twisting it counter clockwise. Locate the reference arrows(5) on the face of the
laser. The arrow pointing to the U is the arrow that should be pointing straight up.
Twist the entire laser unit within the mount to get it square. When the arrows are
perfectly square up and to the right you have successfully aligned your laser. Next,
tighten the Laser Mount Screw(2) to secure your settings. Now you can mount the
unit by removing the two Barrel Mounting Screws(11). Place the Universal Barrel