NcSTAR AAPRLS - Manual

AAPRLS INSTRUCTIONS
LOW PROFILE PISTOL RED LASER
 PLEASE FOLLOW ALL OF THE DIRECTIONS IN THIS MANUAL CAREFULLY.
 CAUTION: ALWAYS PRACTICE SAFE FIREARMS HANDLING!
 BE SURE THAT THE FIREARM IS UNLOADED AND SAFE BEFORE PERFORMING ANY OF THE FOLLOWING
PROCEDURES!
 BE SURE THAT THE FIREARM IS POINTED IN A SAFE DIRECTION AT ALL TIMES!
 CAUTION: AVOID SHINING THE LASER IN YOUR EYES OR INTO ANYONE ELSE’S EYES!
FEATURES:
 Sleek compact low profile design.
 Designed to be securely mounted onto most Weaver/ Picatinny style rails.
 Easy to reach Side to Side On/Off switch
 Laser is fully adjustable for Windage and Elevation.
INSTALLATION:
To mount the laser onto a Weaver/ Picatinny style rails, first unscrew and remove the Allen Head Bolt from the
mount of the laser using the supplied Allen wrench. Set aside the Rail Clamp and Allen Head Bolt.
Place and position the laser onto the firearm rail so that a recoil slot aligns up with one of the laser Mount Bolt Holes.
Insert the Allen Head Bolt through the laser body & firearm rail recoil slot and attach the Rail Clamp to the opposite side of
the laser body. Use the Allen wrench to tighten the Allen Head Bolt into the Rail Clamp. Make sure that the Rail Clamp slot is
interfacing with the Rail Clamp Tab on the side of the laser body.
Tighten the Allen Head Bolt until it is snug. Be careful to not over-tighten the Mount Bolt or it may cause damage to
the laser. Your laser is now securely mounted and ready for use.
1) Mount Bolt Holes
2) Side to Side ON/ OFF Switch
3) Rail Clamp Tab
4) Windage Adjustment
5) Rail Clamp
6) Allen Head Bolt
7) Rail Grooves
8) Laser Aperture
SPECIFICATIONS:
 Maximum output power: <5mW
 Wavelength: 635-655 nm
 Battery type: AG13 or LR44 (1.5V button cell battery)
 Requires two Batteries  Length: 2.25”
 Width: 1.11”
 Height: 0.90”
 Weight: 1 oz.