NcSTAR ASLG User Manual
Green laser with one inch scope mount
GREEN LASER WITH ONE INCH SCOPE MOUNT
This Green Laser is designed to mount directly to your one inch scope as an
advantage of quick target acquisition. Use of the laser will not replace the use
of other sighting devices in regards to accuracy, but it will certainly aid in
locating your target with ease.
This Green Laser mounts easily to almost any full size scope with a one inch tube.
You can also mount your new laser to most 12 gauge shotgun tube magazines
with the provided mount
Included in the package are two types of switches: a standard on & off cap
switch(4), and a coil pressure momentary type switch(10). Also included is the
specially designed One Inch Scope Mount(1), two different allen wrenches, and
a CR123A battery.
Always be sure that the unit is off when not in use to preserve battery life.
DANGER:
AVOID DIRECT EYE EXPOSURE TO LASER BEAM. LASER RADIATION IS
EMITTED FROM THE APPERTURE.
MOUNTING:
CAUTION: BEFORE BEGINNING INSTALLATION OF YOUR GREEN
LASER BE SURE THAT THE FIREARM IS UNLOADED. ALWAYS
PRACTICE SAFE FIREARMS HANDLING PROCEDURES.
Your new Green Laser is designed to mount directly to just about any full size one
inch scope. To install, first remove six Mounting Screws(2) on the top of the One Inch
Scope Mount(1) using the provided allen wrench. Next, place the Laser into the
mount as shown in the Front View. Connect the other end of the One Inch Scope
Mount(1) to the tube of your scope. Now, install the Mounting Screws(2), but do not
tighten them yet as shown in the TOP VIEW. The laser must be positioned so that the
unit is right side up. To perform this operation, remove the cap on the front of the
laser housing(3) by twisting it counter clockwise. Locate the reference arrows(5) on
the face of the laser. The arrow pointing to the U is the arrow that should be
pointing straight up. Twist the entire laser unit within the mount to get it square.