NcSTAR DDAB User Manual
Tactical red dot sight
TACTICAL RED DOT SIGHT
This tubeless design reflex lens aperture provides a wide field of view providing
quick target acquisition which makes it suitable for rapid-firing and shooting of
moving targets. This reflex sight will be suitable for many projectile-firing
devices including handguns, shotguns, rifles, air guns, and crossbows.
The red dot is factory-adjusted parallax free to 40 yards. This adjustment ensures
that parallax-related aiming errors are minimized over a large range distance.
Items provided with your new sight include a cover (to protect your red dot while
not in use), two different sized allen wrenches, an extra battery, and a lens
cleaning cloth.
The red dot is equipped with a standard on/off switch which can be found on the
rear of the sight body. While not in use be sure that the unit is covered and the
switch is off to preserve battery life.
MOUNTING:
CAUTION: BEFORE BEGINNING INSTALLATION OF YOUR RED
DOT SIGHT BE SURE THAT THE FIREARM IS UNLOADED. ALWAYS
PRACTICE SAFE FIREARMS HANDLING PROCEDURES.
Your new tactical sight is equipped with an integral rail mounting system that is
designed to fit on any standard weaver-style base. To install, first loosen the two
allen screws on the right side rail using the provided allen wrench (3). Next, set the
sight on top of the base. Notice that one of the screws is protruding from the bottom
of the sight, be sure that this lug fits into one of the grooves of the weaver-style base.
This will ensure stability upon recoil of the firearm. Your tactical sight has unlimited
eye relief so you may mount it in the position that is most comfortable for you. Be
sure not to mount the sight to close to your eye as injury may result upon recoil of the
firearm. Once you have chosen the sight position that best suits you be sure that the
sight is fully seated on the base. Proceed to carefully tighten the allen screws (3)
firmly in place, but do not over tighten. Your new tactical sight is ready for zeroing.